Quick answer
The Kreg Precision Beaded Face-Frame System simplifies creating consistent beaded face frames. Set it up correctly by adjusting the sliding base, clamp, and control arm for your stock thickness, and using the included router table stop for repeatable cuts.
Understanding the System Components
The Precision Beaded Face-Frame System integrates a clamp with a quick-release handle, a sliding base, and a control arm to guide your workpiece smoothly into the router bit. The router table stop ensures you can repeat precise cuts across multiple frame pieces. Before starting setup, familiarize yourself with these parts so adjustments make sense.
Choosing the Right Router Bit and Stock
The system works with variable stock thickness, but your router bit must match the bead profile you want. For face frames, a bead bit with the correct bearing is essential. Ensure your stock is flat and straight; any warp will transfer to the cut and ruin alignment. Set up on a sturdy router table with sufficient space to support long rails and stiles.
Setup Steps for the Precision Beaded Face-Frame System
- Mount the System on Your Router Table: Attach the base of the Precision Beaded Face-Frame System to the router table using the provided mounting holes. Center it over your router bit. Tighten all bolts firmly to prevent movement during operation. Check for level alignment with the table surface to avoid uneven bead depth.
- Adjust the Sliding Base for Smooth Operation: The sliding base rides on 20 stainless-steel ball bearings. If it feels too loose or tight, turn the adjustment screws on the base to remove play without binding. Test by sliding the base back and forth; it should move freely without side-to-side wobble. Over-tightening will cause friction and uneven cuts; aim for a snug, glide-like feel.
- Set the Clamp Height for Your Stock Thickness: Using the quick-release handle, open the clamp and place a scrap piece of your face-frame stock under it. Close the clamp and adjust the height knob until the clamp applies firm, even pressure across the workpiece. The handle should click into the locked position without excessive force. If the handle requires a lot of force to lock, lower the clamp slightly; if it locks too easily, the piece may shift during cutting.
- Position the Control Arm: The control arm steadies the workpiece as it plunges into the bit. Loosen the control arm's locking knob and set it so that the workpiece contacts the arm before reaching the router bit. Tighten the knob. The arm should guide the piece smoothly without dragging. Position the control arm too far forward and the workpiece may kick; too far back and the arm won't provide guidance.
- Install and Set the Router Table Stop: Attach the included router table stop to the fence or table extension. Position it so that when the workpiece contacts the stop, the bead cut ends exactly where you want. This enables repeatable cuts across multiple stiles and rails. Test on scrap first: cut one piece, measure the bead length, then adjust the stop before cutting your final stock.
- Perform a Test Cut and Fine-Tune: With all adjustments made, run a test piece through the system. Check the bead depth, consistency, and stop position. If the bead is too shallow or deep, lower or raise the router bit slightly and re-test. Adjust the stop if the bead length is off. Never skip the test cut—stock variation or bit projection changes can ruin a full frame.
Key Product Details
- Precision Beaded Face-Frame System: Includes an integrated clamp with a quick-release handle and adjustability for variable stock thickness. You don't need a separate clamp setup, and you can use different wood thicknesses without buying extra adapters.

Precision Beaded Face-Frame System

