Category: Prodotti
Ran it through both oak and maple plywood on the hinge jig, and the 24,000 RPM handling keeps the cuts perfectly clean without any tear-out. The carbide tips are holding up great after a few dozen mortises, and the 1/4" shank fits my trim router without any wobble. Exactly what I needed for consiste
Carbide tips still razor sharp after a full set of doors, and the flush cuts come out so clean I barely had to sand the hinge pockets. Spins steady at 24,000 RPM without any chatter, even in oak.
I’ve been routing hinge mortises all afternoon and the carbide tips are still sharp as new, no burning even at 24,000 RPM. The 1/4" shank fit snugly in my trim router and produced perfectly clean, precise cuts on every pass. For the price, this bit is an absolute workhorse.
