Category: Produtos
Drilled about thirty holes for shelf pins this afternoon and the brad point tip bit in cleanly every single time, no wandering at all. The 6mm hex shank clicked right into my drill chuck and stayed put.
Doesn't exactly fit every 5mm jig, but once it's seated in the chuck, the brad point tip starts drilling clean and straight without wandering. I've used it on a few shelves now and the holes come out smooth enough for pins.
The 6mm hex shank locks into my drill chuck without any wobble, which makes a big difference when you're using a jig. Holes come out clean and the bit stays sharp after drilling a few dozen shelf pin holes. Just wish it came in a small case so I didn't have to dig for it in my toolbox.
