Drawer Front Mounting Jig: Align Drawer Fronts Perfectly
By Welcome to Kreg Tool | Published: 2026-10-26
Category: How-to Guides
Learn how to align drawer fronts perfectly with a drawer front mounting jig. Step-by-step guide to install drawer fronts with even gaps and professional results.
Quick answer
Use a drawer front mounting jig with alignment marks and a non-slip surface to hold each drawer front in place while you secure it, ensuring consistent gaps and a professional finish.
Why a jig beats measuring each drawer
Measuring and clamping each drawer front individually is slow and error-prone. A drawer front mounting jig gives you repeatable alignment, so every drawer sits at the same height and spacing.
The jig's alignment marks let you set the same reveal around each drawer, while the GripMaxx™ anti-slip surface keeps the front from shifting when you drive screws.
Trade-off: fixed spacing vs. custom gaps
Most jigs work best with a consistent gap, like 1/8 inch. If you want a larger or asymmetric reveal, you may need to adjust the jig position or use shims for that specific drawer.
The jig speeds up standard installations, but for custom spacing, plan a little extra time to fine-tune each drawer.
How to align drawer fronts with a jig
- Prepare the drawer box and front: Make sure the drawer box is square and the front is the correct size. Sand or pre-drill if needed. Check that the drawer front overlaps the opening evenly on all sides before you start.
- Set the jig on the drawer box: Place the jig on the drawer box, aligning its marks with the edge of the box. Tighten the knobs so it stays put. Don't over-tighten; the jig should be secure but still easy to remove.
- Position the drawer front: Set the drawer front on the jig, pressing it against the anti-slip surface. Use the alignment marks to set your desired reveal. Check that the gap is even on both sides before fastening.
- Secure the drawer front: Drive screws through the drawer box into the front while the jig holds it in place. Work from the inside so screws are hidden. Use clamps if the jig doesn't hold both edges; avoid driving screws at an angle.
- Repeat for remaining drawers: Move the jig to the next drawer box and repeat the process, using the same alignment marks for consistent spacing. Check the gap between drawers after each installation to catch any drift early.
What to look for in a drawer front jig
- Drawer Front Mounting Jig: Alignment marks ensure accuracy and quick setup. You can set the same reveal on every drawer without measuring each time, saving time and reducing errors.
Drawer Front Mounting Jig - Drawer Front Mounting Jig: GripMaxx™ anti-slip surface holds the drawer front in place. The drawer front won't slide while you drive screws, so the alignment stays put.
